Optional Tasks On Atm 1483 Subinterfaces - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Optional Tasks on ATM 1483 Subinterfaces

atm aal5 shutdown
atm aal5 snmp trap link-status
atm atm1483 advisory-rx-speed
Copyright © 2010, Juniper Networks, Inc.
Disable an interface.
host1(config-if)#shutdown
You can perform the following optional tasks on ATM 1483 subinterfaces:
Set the MTU.
host1(config-subif)#atm atm1483 mtu 7800
Configure SNMP link status traps.
host1(config-subif)#atm atm1483 snmp trap link-status
Set the administrative state of an ATM 1483 subinterface to disabled.
host1(config-subif)#atm atm1483 shutdown
Configure an advisory receive speed.
host1(config-subif)#atm atm1483 advisory-rx-speed 2000
Use to set an ATM AAL5 interface administrative state to disabled.
When you set the administrative state of the ATM AAL5 interface to disabled, the
router automatically disables all F5 OAM services configured on the associated VC,
and prevents the VC from receiving or transmitting F5 OAM cells.
Example
host1(config-if)#atm aal5 shutdown
Use the no version to enable a disabled interface.
See atm aal5 shutdown.
Use to enable SNMP link status traps on the AAL5 layer interface.
Example
host1(config-if)#atm aal5 snmp trap link-status
Use the no version to disable the traps.
See atm aal5 snmp trap link-status.
Chapter 1: Configuring ATM
25