Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 119

Copyright © 2010, Juniper Networks, Inc.
Assigned profile—For each dynamic interface type, indicates whether or not a profile
is assigned and, if assigned, displays the profile name
Interface Alias—Text description or alias if configured for the subinterface
Subscriber info—Subscriber login information for the specified dynamic interface
type (bridged Ethernet or IP)
Assigned VC Class—Name of the VC class assigned to this subinterface, if configure
SNMP trap link-status—Trap link status: enabled or disabled
Advisory receive speed—Configured receive speed, in Kbps, for the dynamic ATM 1483
subinterface. The E Series LAC sends this value to the LNS in the RX Connect-Speed
AVP [38].
InPackets—Number of packets received on this interface
InBytes—Number of bytes received on this interface
OutPackets—Number of packets transmitted on this interface
OutBytes—Number of bytes transmitted on this interface
InErrors—Number of errors received on this interface
OutErrors—Number of outgoing errors on this interface
InPacketDiscards—Number of incoming packets discarded on this interface
InPacketsUnknownProtocol—Number of incoming packets with an unknown protocol
type
OutDiscards—Number of outgoing packets discarded on this interface
Example 1—Displays the current state of all ATM subinterfaces
host1#show atm subinterface
Interface ATM-Prot VCD VPI VCI Type
----------- -------- --- --- --- ----- ----- ---- -------------- ---------
ATM 2/0.101 RFC-1483 101
ATM 2/0.102 RFC-1483 102
ATM 2/0.103 RFC-1483 103
3 interface(s) found
Example 2—Displays summary information for all ATM subinterfaces shown in Example
1
host1#show atm subinterface summary
3 subinterfaces: 1 up, 0 down,
1 dormant, 1 dormantLockout,
0 lowerLayerDown, 0 not present
Example 3—Displays status information about the current state of all ATM subinterfaces
in the dormantLockout state
Circuit
Encap MTU
0 101 PVC AUTO 9180 dormantLockout Static
0 102 PVC AUTO 9180 up
0 103 PVC AUTO 9180 dormant
Chapter 1: Configuring ATM
Interface
Status Type
Dynamic
Static
87