Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 107

Copyright © 2010, Juniper Networks, Inc.
Assigned VC Class—Name of the VC class assigned to this interface, if configured
InPackets—Number of packets received on this interface
InBytes—Number of bytes received on this interface
InCells—Number of cells received on this interface
OutPackets—Number of packets transmitted on this interface
OutBytes—Number of bytes transmitted on this interface
OutCells—Number of cells transmitted on this interface
InErrors—Number of incoming errors received on this interface
OutErrors—Number of outgoing errors on this interface
InPacketDiscards—Number of incoming packets discarded on this interface
InByteDiscards—Number of incoming bytes discarded on this interface
InCellErrors—Increments when a T3 or an E3 ATM interface receives cells for a VPI
or VCI that is not configured on that interface
Field descriptions specific to the applicable physical interface. In Example 1, the output
contains the following physical interface fields:
SONET path operational status—State of the SONET path interface: up, down,
lowerLayerDown
time since last status change—Time since last reported change to the SONET path
operational status
SONET operational status—State of SONET interface: up, down, lowerLayerDown
time since last status change—Time since last reported change to the SONET
operational status
PHY Type—Physical port type on which this interface is running
Framing—Framing type of the physical interface
TX clocking—Clocking type for the physical interface
Loopback—Loopback status for the physical interface: enabled, disabled
Receive FIFO Overruns—Number of times received FIFO was overrun
qos-mode-port—Status of SAR backpressure: enabled, disabled
queue—Hardware packet queue associated with the specified traffic class and
interface
Forwarded packets, Bytes—Number of packets and bytes forwarded on this queue
Chapter 1: Configuring ATM
75