Table of Contents
Advertisement
Abbreviated Table of Contents
Part 1
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Chapter 10
Chapter 11
Chapter 12
Chapter 13
Chapter 14
Chapter 15
Chapter 16
Chapter 17
Chapter 18
Part 2
Copyright © 2010, Juniper Networks, Inc.
About the Documentation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xxix
Configuring ATM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Configuring Frame Relay . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 105
Configuring Multilink Frame Relay . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 131
Configuring VLAN and S-VLAN Subinterfaces . . . . . . . . . . . . . . . . . . . . . . . . 167
Configuring 802.3ad Link Aggregation and Link Redundancy . . . . . . . . . . 197
Configuring IEEE 802.3ah OAM Link-Fault Management . . . . . . . . . . . . . . 223
Configuring Point-to-Point Protocol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 259
Configuring Multilink PPP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 299
Configuring Multiclass Multilink PPP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 345
Configuring Packet over SONET . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 359
Configuring Point-to-Point Protocol over Ethernet . . . . . . . . . . . . . . . . . . . . 371
Configuring Bridged IP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 437
Configuring Bridged Ethernet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 443
Configuring Transparent Bridging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 465
Configuring Cisco HDLC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 503
Configuring Dynamic Interfaces . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 511
Configuring Dynamic Interfaces Using Bulk Configuration . . . . . . . . . . . . . 619
Index . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 709
vii
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 and is the answer not in the manual?
Questions and answers