Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 325

Copyright © 2010, Juniper Networks, Inc.
maximum-rechallenge-timeout
EAP Protocol Configuration
request-retry
request-timeout
Example 2—Provides detailed output for a particular IPv6 interface
host1#show ppp interface fastEthernet 12/0.1.1 full
PPP interface FastEthernet 12/0.1.1 is lowerDown
Interface administrative status is open
Configured network protocol is IPV6CP
IPCP protocol configuration
configured
administrative-status
ip-address
dns-precedence
wins-precedence
ipcp-netmask-option
ipcp-lockout-option
max-negotiations
IPCP protocol status
operational-status
IPV6CP protocol configuration
configured
administrative-status
ipv6-interfaceId
IPV6CP protocol status
operational-status
terminate-reason
OSINLCP protocol configuration
configured
administrative-status
OSINLCP protocol status
operational-status
Interface statistics
packets
octets
errors
discards
LCP protocol configuration
max-receive-unit
authentication
magic-number
magic-number-mismatch
keepalive-timer
restart-timer
max-terminate
max-configure
max-failure
passive-mode
LCP protocol status
link-status
LCP protocol statistics
in-keepalive-requests
Chapter 8: Configuring Point-to-Point Protocol
0 seconds
5
3 seconds
false
open
0.0.0.0
local
local
disabled
enabled
10
not present
true
open
90:1a00:140:4b39
down
link down
false
open
not present
in out
0 0
1163 706
0 0
153482 0
use lower layer
none
enabled
reject
30 seconds
3 seconds
2
10
5
disabled
initial
11
293