Creating a Basic Configuration
Copyright © 2010, Juniper Networks, Inc.
Configuring an NBMA Interface on page 38
Creating an NBMA Static Map on page 38
Assigning Descriptions to Interfaces on page 40
Sending Interface Descriptions to AAA on page 41
Configuring Individual ATM PVC Parameters on page 43
Configuring ATM VC Classes on page 53
Configuring Dynamic ATM 1483 Subinterfaces on page 66
To configure ATM, perform the following tasks. (Figure 3 on page 22 shows the relationship
of Steps 1 through 3.)
Configure an ATM physical interface.
1.
host1(config)#interface atm 0/1
Configure an ATM 1483 subinterface.
2.
host1(config-if)#interface atm 0/1.20
Configure a PVC by specifying the VCD, the VPI, the VCI, and the encapsulation type.
3.
host1(config-subif)#atm pvc 10 15 22 aal5snap
Assign an IP address and subnet mask to the PVC.
4.
host1(config-subif)#ip address 192.32.10.20 255.255.255.0
(Optional) Verify your configuration using the appropriate show commands.
5.
host1#show atm interface atm 0/1
host1#show atm vc atm 0/1 10
host1#show atm subinterface atm 0/1.20
Chapter 1: Configuring ATM
21