Monitoring Dos Protection Groups - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide

Monitoring DoS Protection Groups

Use the commands described in this section to monitor DoS protection groups.
show dos-protection-group
472
Denial of Service (DoS) Protection
Use to display DoS protection groups.
If you do not specify a group, displays the names of the currently configured
DoS protection groups.
If you specify a group, displays information about the specified group.
If you do not specify the brief keyword, displays a list of references (interfaces
and templates) to the DoS protection group,
When *modified* appears next to the name of the DoS protection group. the
group or protocol within the group has changed from the preprogrammed value
of the associated group.
Example
host1(config)#show dos-protection-group
DOS Protection Groups:
Default (canned-group: " default" )
Uplink (canned-group: " link"
ATM (canned-group: " pppoe"
VLAN (canned-group: " mixed-access" )
See show dos-protection-group.
*modified*
}
) *modified*