Monitoring Dos Protection Groups - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Monitoring DoS Protection Groups

show dos-protection-group
Copyright © 2010, Juniper Networks, Inc.
Use the commands described in this section to monitor DoS protection groups.
Use to display DoS protection groups.
If you do not specify a group, displays the names of the currently configured DoS
protection groups.
If you specify a group, displays information about the specified group.
If you do not specify the brief keyword, displays a list of references (interfaces and
templates) to the DoS protection group,
When *modified* appears next to the name of the DoS protection group. the group or
protocol within the group has changed from the preprogrammed value of the associated
group.
Example
host1(config)#show dos-protection-group
DOS Protection Groups:
Default (canned-group: " default" )
Uplink (canned-group: " link"
ATM (canned-group: " pppoe"
VLAN (canned-group: " mixed-access" )
See show dos-protection-group.
Chapter 7: Passwords and Security
*modified*
}
) *modified*
457