Configuring Pppoe Over A Static Ethernet Interface; Figure 9: Example Of Ip Over Ethernet Stacking Configuration Procedure; Figure 10: Example Of Pppoe Stacking Configuration Procedure - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide

Configuring PPPoE over a Static Ethernet Interface

154
host1(config-if)#ip address 192.5.127.8 255.255.255.0
Figure 9 on page 154 illustrates this configuration.

Figure 9: Example of IP over Ethernet Stacking Configuration Procedure

To configure PPPoE over an Ethernet interface:
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.
1.
host1(config)#interface fastEthernet 4/1
Specify PPPoE as the encapsulation method on the interface.
2.
host1(config-if)#pppoe
Create a PPPoE subinterface.
3.
host1(config-if)#pppoe subinterface fastEthernet 4/1.1
Specify PPP as the encapsulation method on the interface.
4.
host1(config-if)#encapsulation ppp
Assign an IP address and mask.
5.
host1(config-if)#ip address 164.10.6.51 255.255.255.0
(Optional) Configure additional PPPoE subinterfaces by completing Steps 3 through
6.
5 using unique numbering.
Figure 10 on page 154 illustrates this configuration.

Figure 10: Example of PPPoE Stacking Configuration Procedure

Copyright © 2010, Juniper Networks, Inc.