Configuring Ip And Mpls Over A Static Ethernet Interface; Configuring Ip, Mpls, And Pppoe Over Ethernet; Figure 10: Example Of Pppoe Stacking Configuration Procedure; Figure 11: Example Of Ip And Mpls Stacking Configuration Procedure - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual
For e series broadband services routers - link layer configuration
Table of Contents
Advertisement
Figure 10: Example of PPPoE Stacking Configuration Procedure
Configuring IP and MPLS over a Static Ethernet Interface
To configure both IP and MPLS over an Ethernet interface:
1.
2.
3.
Figure 11 on page 157 illustrates this configuration.
Figure 11: Example of IP and MPLS Stacking Configuration Procedure
Configuring IP, MPLS, and PPPoE over Ethernet
To configure IP, MPLS, and PPPoE over an Ethernet interface:
1.
2.
Chapter 4: Configuring Upper-Layer Protocols over Static Ethernet Interfaces
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.
host1(config)#interface fastEthernet 4/0
Create an IP interface.
host1(config-if)#ip address 192.5.127.8 255.255.255.0
Create an MPLS interface.
host1(config-if)#mpls
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.
host1(config)#interface fastEthernet 4/0
Create an IP interface.
Configuring IP and MPLS over a Static Ethernet Interface
157
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 and is the answer not in the manual?