Table of Contents
Advertisement
Meaning
Related
Documentation
Example: Configuring Shared Interfaces (Ethernet)
Requirements
Copyright © 2010, Juniper Networks, Inc.
ANSI LMI settings: n391dte 6, n392dte 3, n393dte 4, t391dte 10 seconds
CoS queues
: 8 supported, 8 maximum usable queues
Last flapped
: Never
Input rate
: 0 bps (0 pps)
Output rate
: 0 bps (0 pps)
Logical interface so-6/0/0.3 (Index 68) (SNMP ifIndex 19352)
Flags: Point-To-Point SNMP-Traps 0x4000 Encapsulation: FR-NLPID
Shared interface:
Peer interface: ut-7/0/0.3
Tunnel token: Rx: 2.455, Tx: 1.456
Input packets : 9
Output packets: 10
Protocol inet, MTU: 4470
Addresses, Flags: Is-Preferred Is-Primary
Destination: 16.16.0.0/30, Local: 16.16.0.1, Broadcast: 16.16.0.3
DLCI 100
Flags: Active
Total down time: 00:00:00 sec, Last down: 00:00:55 ago
Input packets : 9
Output packets: 10
DLCI statistics:
Active DLCI
:1
Inactive DLCI
Under the
Physical interfaces
value of
Non-owner
, indicating that the shared physical interface
by PSD6. The
Shared interface
.
ut-7/0/0.3
Configuring Shared Interfaces on the RSD on page 95
Configuring Shared Interfaces on a PSD on page 97
In this configuration example, two Protected System Domains (PSDs) share a single
interface on a Flexible PIC Controller (FPC) that is owned by the Root System Domain
(RSD).
Requirements on page 147
Overview on page 148
Configuration on page 148
Verification on page 154
This configuration example requires the following hardware and software components:
Junos OS Release 9.4 or later
JCS1200 platform with Routing Engines in slots 5, 6, and 7
T640 router with FPCs in slots 1 through 7
:0
section of the output, the
field for
indicates that its peer interface is
so-6/0/0.3
Chapter 14: Configuration Examples
field displays a
Shared-interface
so-6/0/0
is not owned
147
Advertisement
Table of Contents
