Table of Contents
Advertisement
Related Topics
Configuring a T640 Router on a Routing Matrix (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 48: FPC Configuration Details (continued)
Task
Associate a sampling
instance.
Configuring Aggregated Devices (NSM Procedure) on page 97
Configuring Chassis Alarms (NSM Procedure) on page 98
Configuring a T640 Router on a Routing Matrix (NSM Procedure) on page 105
To configure a T640 router on a routing matrix in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Chassis > Lcc.
3.
Add or modify settings as specified in Table 49 on page 105.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 49: Lcc Configuration Details
Task
Configure the T640 routing
node.
Your Action
1.
Click Add new entry next to Fpc.
2.
Click Sampling Instances next to fpc.
3.
Click Add new entry next to Sampling Instances.
4.
From the Name list, select the sampling instance name.
5.
In the Comment box, enter the comment.
Your Action
1.
Click Add new entry next to Lcc.
2.
From the Name list, select the number that specifies a T640
router on a routing matrix.
Range: 0 through 3
3.
In the Comment box, enter the comment.
4.
Select one of the following:
online-expected—On a TX Matrix router, configures a T640
router so that if it does not come online, an alarm is sent
to the TX Matrix router. On a TX Matrix Plus router, configure
a T1600 router so that if it does not come online, an alarm
is sent to the TX Matrix Plus router.
offline—On a TX Matrix router, configures a T640 router
so that it is not part of the routing matrix. On a TX Matrix
Plus router, configure a T1600 router so that it is not part
of the routing matrix.
Chapter 11: Configuring Chassis
105
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?