Snmp Trap Group - Alcatel-Lucent 7450 System Management Manual

SNMP Trap Group

An event log can be configured to send events to SNMP trap receivers by specifying an SNMP
trap group destination.
An SNMP trap group can have multiple trap targets. Each trap target can have different
operational parameters.
A trap destination has the following properties:
•
•
•
•
•
For SNMP traps that will be sent out-of-band through the Management Ethernet port on the SF/
CPM, the source IP address of the trap is the IP interface address defined on the Management
Ethernet port. For SNMP traps that will be sent in-band, the source IP address of the trap is the
system IP address of the router.
Each trap target destination of a trap group receives the identical sequence of events as defined by
the log ID and the associated sources and log filter applied.
Syslog
An event log can be configured to send events to one syslog destination. Syslog destinations have
the following properties:
•
•
•
•
7450 ESS System Mangement Guide
The IP address of the trap receiver.
The UDP port used to send the SNMP trap.
SNMP version (v1, v2c, or v3) used to format the SNMP notification.
SNMP community name for SNMPv1 and SNMPv2c receivers.
Security name and level for SNMPv3 trap receivers.
Syslog server IP address.
The UDP port used to send the syslog message.
The Syslog Facility Code (0 - 23) (default 23 - local 7).
The Syslog Severity Threshold (0 - 7) - events exceeding the configured level will be sent.
Event and Accounting Logs
Page 383