Maintenance 7. Service Utility
(1)
Set the operating conditions of Parameter Updating Editor that is used to
edit Exposure Menu and Image Processing Parameters when the IPU function
is active.
• [starting mode:]:
Set the operating mode of Parameter Updating Editor (default: user mode).
• [user mode]:
• [maintenance mode]: A mode to be used for editing based on one that
• [parameter change:]:
Set the appearance of the Image Processing Parameters editing screen of
Parameter Updating Editor.
• [MFP:]:
• [PEM:]:
(2)
Set the parameters and click [OK].
→ The [Protocols] window on the [SERVICE UTILITY] window reappears.
Setting Data receive if the printer is off-line (supporting software ver. A04 or later)
(1)
Set the print accepting method corresponding to printer status (default:
disable).
• [enable]: Print is accepted regardless of the status while starting up
• [disable]: Print is only accepted in the [Operating] status while starting
(2)
Set the parameters and click [OK].
→ The [Protocols] window on the [SERVICE UTILITY] window reappears.
006-251-05
05.30.2001 FM3069
A mode to be used for editing based on the
standard menu codes (a mode for user operation).
includes other than standard menu codes. In this
setting, the following [parameter change:] setting
does not exist (all Image Processing Parameters
are editable.)
Select either [disable](default:disappear) or [enable](appear)
for the Image Processing Parameters editing screen of Multi-
objective frequency processing.
Software ver. A04 or later: Select either [disable] (default:
disappear) or [enable] (appear) for the Image Processing
Parameters editing screen of Pattern enhancement processing
for mammography.
Software ver. A03 or earlier: Cannot be used, leave it [disable]
(default: disappear).
or operating the FN-PS551 application.
The image data is stored in the hard disk, and the print output
is performed after the status is returned to [Operating].
up or operating the FN-PS551 application.
Maintenance-59
FN-PS551 Service Manual Maintenance-59