Table of Contents
Advertisement
Installation
2. Setting Up the Equipment
Install the Expansion Card Cage
Install the expansion card cage in the reverse order of the removal procedure.
REFERENCE
Refer to the illustrations in "
(1)
With the card cage lever in the vertical position, align the slots on the left side
of the expansion card cage with the tabs on the left side panel of the chassis.
(2)
Rotate the card cage lever downwards until it stops at a horizontal position.
Check that the riser board is pushed down fully into the riser connector on
the system board.
Re-attach Control Main Unit Cover
Re-attach the control main unit cover in the reverse order of the removal procedure.
REFERENCE
Refer to the illustrations in "
(1)
Check that no parts such as screws are left inside the control unit, and that
internal cable are stowed out of the way.
(2)
Align the front of the cover with the front of the control unit. Align the three
cover hooks with the holes at the lower front part of the chassis.
REFERENCE
It is easier to check that the hooks are aligned at their designated positions
by looking straight down on the chassis from above.
(3)
Gently lower the control main unit cover into its designated position on the
chassis.
→ Press down the cover until the two cover buttons click into position.
006-251-04
07.24.2000 FM2824
Remove the Expansion Card Cage".
Remove the Control Main Unit Cover".
FN-PS551 Service Manual Installation-22
Installation-22
Advertisement
Chapters
Table of Contents
