FujiFilm FN-PS551 Service Manual page 72

Maintenance 7. Service Utility
• [Print Server Application Entity]:
This parameter specifies the type of application entity titles (AE Title) assigned
to the FN-PS551 system. When two printers are connected, an AE Title for
each printer (so that the each printer are seen as an independent unit) or an
AE Title for the complete system (so that two printers are seen as a single
unit) can be specified.
This setting will depend on the system operation method in the relevant
location, so check with the relevant users before changing it.
• [one to each printer]: Assigns a AE Title to each printer.
• [one to both printers]: Assigns a AE Title to the complete system. In
NOTE
• If [one to each printer] is set, print output is performed only to the printer
specified with the AE Title by the client.
• If [one to both printers] is set, print output is performed on the printer set at
"
[Clients]" although the AE Title specified by the client is that of Printer #1.
• [Data receive if the printer is off-line] (supporting software ver. A04 or later):
Print accepting method corresponding to printer status (default value: enable).
• [enable]: Print is accepted regardless of the status while starting up or
• [disable]: Print is only accepted in the [Operating] status while starting
(2) Set the parameters and click [OK].
→ The [Protocols] window on the [SERVICE UTILITY] window reappears.
006-251-07
10.28.2002 FM3487
[printer] Window" in the "7.5 Adding, Modifying, or Deleting a Client
operating the FN-PS551 application.
The image data is stored in the hard disk, and the print output
is performed after the status is returned to [Operating].
up or operating the FN-PS551 application.
this case, the AE Title for "Printer #1" is applied
("Printer #1" is connected to the first printer
interface board).
FN-PS551 Service Manual Maintenance-53.2
Maintenance-53.2