FujiFilm FN-PS551 Service Manual page 171

Maintenance 8. Software Installation
Starting the Installer
(1) With the power off, insert the disk labeled "Windows NT Workstation Setup
Disk #1" into the floppy disk drive. Turn on the monitor, and then the control
unit.
CAUTION
Make sure that the power is switched off before beginning this procedure as
the computer starts up from "Setup Disk #1" as the boot device.
→ Once the system has finished reading the first disk (this takes approximately 90
seconds), the following messages [Please insert the disk labeled Windows NT
Workstation Setup Disk #2 into Drive A:] appears.
006-251-06
12.18.2001 FM3271
Maintenance-142
FN-PS551 Service Manual Maintenance-142