Table of Contents
Advertisement
Maintenance 10. Installing Software for GX150 Series Control Unit
10.1
Installing Windows NT
Preparation
To install Windows NT, it is necessary to startup from the CD-ROM using the
"Reinstallation CD" enclosed with the control unit (PC).
Use the setup utility (BIOS) to set for start up from the CD-ROM.
Outline of procedure is shown below.
CAUTION
Do not change the settings of items that are not specified, using the setup
utility (BIOS). If items that are not specified are changed, the system may
not operate properly.
(1)
When "F2=Setup" appears at the top right of the screen displaying the "DELL
logo mark" after switching on the power to the control unit, press <F2> key.
→ The setup utility (BIOS) screen appears.
(2)
Select [Boot Sequence] using <↑> or <↓> key, and press <Enter> key.
(3)
Note down the contents of current [Boot Sequence] (startup order) in a
memorandum in order to recover the settings after installation of Windows
NT is complete.
(4)
Select [IDE CD-ROM Device] using <↑> or <↓> key, and set [IDE CD-ROM
Device] at the top using <–> (minus/move upwards) or <+> (plus/move
downwards) key.
(5)
After checking that [Save Changes and Exit] is selected on the termination
window of the setup utility (BIOS), which is displayed by pressing <Esc> key
twice, then press <Enter> key.
→ The setup utility (BIOS) finishes and system restarts.
(6)
To continue installing Windows NT after restarting is complete, insert the
"Reinstallation CD" into the CD-ROM drive.
Perform the following step (8) if installation of Windows NT is not to be
performed.
(7)
When the CD-ROM is inserted, the [Windows NT CD-ROM] window appears.
Click close box
(8)
Perform shutdown procedure, and switch off the power to the control unit.
006-251-06
12.18.2001 FM3271
to close the window.
Maintenance-266
FN-PS551 Service Manual Maintenance-266
Advertisement
Chapters
Table of Contents
