FujiFilm FN-PS551 Service Manual page 313

Maintenance 11. Installing Software for GX260 Series Control Unit
(8) In the same manner, select the remaining "Unpartitioned space xxxxxMB",
press <C> key (creation of partition) and press <Enter> key leaving the figure
displayed under "Create Partition of Size (in MB): xxxxx" as it is (D partition).
NOTE
When "Unpartitioned space xMB" is displayed after C and D partitions are
created, leave this as it is.
(9) Choose "C:Partition2 [New(Raw)] xxxxxMB" as the partition for installation of
Windows XP, and press <Enter> key (Install).
(10) On the partition format selection screen, choose "Format the partition using
the NTFS file system", then press <Enter> key.
Then, formatting of the hard disk, copying of Windows XP files and restart of
computer are performed automatically.
NOTE
Hereafter, [Press any key to boot from CD] is displayed during restarting,
however, do not perform any operations at that time.
(11) [Windows XP Professional Setup] wizard appears, so enter the necessary
information following the instructions displayed on the screen.
• For Regional and Language Options, do not change from "English
• For Personalize Your Software, enter "fieldengineer" in the [Name]
• For Computer Name and Administrator Password, enter a computer
NOTE
• The computer name (host name) must be entered in single-byte
alphanumeric characters.
• The computer name (host name) is displayed in upper case once entered
in either lower case or upper case.
• For the FUJI protocol (FINP), the maximum length of computer name
(host name) is limited to 10 characters. For other protocols, it is limited to
15 characters.
• The computer name (host name) must be a unique name within the
installation site. If more than one FN-PS551 is used in the same installation
site, each unit must be given a different name.
• For Date and Time Settings, check that [Time Zone] and [Date & Time]
006-251-07
10.28.2002 FM3487
(United States)", which is set as the default.
field and "FUJIFILM" in the [Organization] field.
name (host name, e.g., "FN-PS551") in the [Computer name] field. Then
enter the password character string "pc-ps" in lower case in both the
[Administrator password] and [Confirm password] fields.
are correct (readjust if they are wrong).
Maintenance-284
FN-PS551 Service Manual Maintenance-284