FujiFilm FN-PS551 Service Manual page 432

Appendix Chapter 2. Service Utility-Additional Instructions
Supplementary Explanation of Settings
This section explains settings of area 0 and area 1.
• Selecting Display Area
The [26. Print film character field] is used to select the display of area 0 and area 1.
• Specifying Area Size
For the standard size, specify the horizontal and vertical sizes for each area from the [27. Character Area0
(Standard) horizontal size] to [30. Character Area1 (Standard) vertical size] .
vertical size
For the large size, specify the horizontal and vertical sizes for each area from the [31. Character Area0
(Large) horizontal size] to [34. Character Area1 (Large) vertical size] .
vertical size
It is noted that the large size is selectable from the [23. 14*17 single character size of 14*17 film] only
when 14" × 17" sized image is output in an equal scaling. For other image output, the standard size is
used.
• Defining Area position and rotation
The definition of area position and rotation is represented as shown in the following figure.
Position 0
(top left
corner)
Position 2
(bottom left
corner)
006-251-01
05.12.99 FM2442
horizontal size
Area 0 vertical size
horizontal size
Area 0 vertical size
Position 1
(top right
corner)
Image area
Position 3
(bottom right
corner)
Position definition
horizontal size
Area 1
FP4G0218.EPS
horizontal size
Area 1
FP4G0219.EPS
No rotation
Image area
Rotation definition
FN-PS551 Service Manual
Appendix-35
FP4G0220.EPS
Appendix-35