FujiFilm FN-PS551 Service Manual page 144

Maintenance 7. Service Utility
NOTE
For software ver. A05 or later, "
and " Setting Image Frames Layout" are set for each client separately. When
using software ver. A05 or later, refer to "
" Using [Network Client Property] Window" from "7.5 Adding, Modifying, or
Deleting a Client [Clients]".
Setting Margin between Image Frames (supporting software ver. A00 to A04)
(1) Specify a value in pixels in [a margin between image:] in the range of 0 to 50
(default is 20).
Normally, the default value for the margin between image frames should be
used. Do not change the default setting unless requested by a user because
of problems with the layout.
Setting Image Frames Layout (supporting software ver. A04)
(1) [Image layout:] Sets how image frames are arranged.
• [concentration]: Sets the image frames in the center of film (secures the
• [spread]:
NOTE
For [concentration], all image sizes arranged on a film should be the same.
Image size varies in the following cases, so even if [concentration] is set,
images are arranged by [spread].
• When images of different sizes are included on an one film.
• For DICOM protocol, when output image size on a film (width of image) is
specified (Requested Image Size) in the image data sent from a client.
006-251-05
05.30.2001 FM3069
Setting Margin between Image Frames"
setting value of [a margin between image:]). (default
setting)
Sets the image frames in the center within each of the
remaining image blocks that are secured by the setting
value of [a margin between image:].
Maintenance-115
[output format] Window" of
FN-PS551 Service Manual Maintenance-115