Table of Contents
Advertisement
Installation
2. Setting Up the Equipment
Install the Expansion Card Cage
Install the expansion card cage in the reverse order of the removal procedure.
REFERENCE
Refer to the illustrations in " Remove the Expansion Card Cage".
(1)
Align the slots on the side of the expansion card cage with the tabs on the
side of the chassis, and push down the expansion card cage while sliding it.
(2)
Check that the riser board is pushed down fully into the RISER connector on
the system board.
Re-attach the Control Main Unit Cover
Re-attach the control main unit cover in the reverse order of the removal procedure.
REFERENCE
Refer to the illustrations in " Remove the Control Main Unit Cover".
(1)
Check that no parts such as screws are left inside the control unit, and that
internal cables are stowed out of the way.
(2)
Gently lower the control main unit cover into its designated position on the
chassis.
→ Press down the cover until the two cover buttons click into position.
006-251-06
12.18.2001 FM3271
Installation-25
FN-PS551 Service Manual Installation-25
Advertisement
Chapters
Table of Contents
