FujiFilm FN-PS551 Service Manual page 28

Maintenance 3. Error Codes
Source Name: TPrc
Event ID Level
1 Warning
2 Warning
3 Warning
4 Warning
5 Warning
6 Warning
7 Warning
10 Warning
006-251-03
03.30.2000 FM2730
Message
(Resource error)Hard disk
is full.
(Resource error)Hard disk
is full.
(Information)Print request
could not accepted
(shutdown process in
progress).
(Information)There is no
film.
(Information)There is no
chemical.
(Information)Laser Printer is
not available.
(Information)Laser Printer is
not available.
(Illegal input data)Image set
ID is invalid.
Cause
Not enough space on the
HDD.
The HDD is full.
Data was transmitted
from the other device
during shutdown.
Data was received, but
there is no film in the FL
-IM.
Data was received, but
there is no chemical in
the FL-IM.
Data was received, but
the FL-IM is temporarily
disabled.
Data was received, but
the FL-IM is unusable
due to fatal error.
The message set ID in
the received image is
incorrect.
FN-PS551 Service Manual Maintenance-15
Maintenance-15
Remedy
Suspend transmission to
connected devices and
wait until space appears on
the HDD. Check that the
memory size per film is
correctly set in the Service
Utility.
Suspend transmission to
connected devices and
wait until space appears on
the HDD. Check that the
memory size per film is
correctly set in the Service
Utility.
The fact that transmission
from other device occurred
is recorded in the log, but
output processing does not
take place. Restart the
system and send the
image(s) again.
The FL-IM status code is
displayed in the status
column, and the fact that
transmission from other
device occurred is
recorded in the log, but
output processing does not
take place.
The FL-IM status code is
displayed in the status
column, and the fact that
transmission from other
device occurred is
recorded in the log, but
output processing does not
take place.
The FL-IM status code is
displayed in the status
column, and the fact that
transmission from other
device occurred is
recorded in the log, but
output processing does not
take place.
The FL-IM status code is
displayed in the status
column, and the fact that
transmission from other
device occurred is
recorded in the log, but
output processing does not
take place.
Check the status of the
other device, the operation
at the time of transmission,
and the transmitted images.
TP4F0011.EPS