Table of Contents
Advertisement
Maintenance 7. Service Utility
• [Adjustment parameter: LUT]:
Specify the following parameters for each LUT number (1 to 8) listed in the
drop-down list.
• [ γ table no.:]:
• [Max. density:]: For SAR, specify the maximum density in multiples of
• [contrast:]:
• [Min. density:]: For SAR, specify the minimum density in multiples of
For the SAR method, the following settings are also required for the tone
correction curve tuning (if used).
• [number of tuning points:]:
Specify the number of tuning points in the range of 0 to 5. The following
values must be set for each tuning point when the number of tuning points is
set to 1 or more.
• [density:]:
• [shift:]:
• [contrast:]:
(13) Click the [printer] tab.
→ The [printer] window appears.
006-251-07
10.28.2002 FM3487
For SAR, range = 11 to 50.
For BAR, range = 1 to 20.
100 × actual value (range = 0 to 300).
For BAR, specify the maximum density by percentage
(range = 1 to 100).
Specify the contrast in multiples of 100 × actual value
(range = 10 to 400).
Also, this contrast setting does not exist for SAR on
software version A04 or later.
100 × actual value (range = 0 to 300). (Note: The
value of the minimum density must be lower than that
of the maximum density.)
For BAR, the minimum density setting is not required.
Specify the tuning density in multiples of 100 (range =
0 to 300).
Follow the rule of minimum density<density<maximum
density.
Specify the shift density in multiples of 100 (range =
-100 to 100).
Follow the rule of minimum density<density ± shift
<maximum density.
Specify the contrast at the tuning point in multiples of
100 (range = 10 to 400).
Maintenance-95
FN-PS551 Service Manual Maintenance-95
Advertisement
Chapters
Table of Contents
