Table of Contents
Advertisement
Maintenance 11. Installing Software for GX260 Series Control Unit
11.5
Installing the Printer Interface Board
When reinstallation is performed from OS for DELL OptiPlex GX260 series (Windows
XP) control unit (PC) models, attach the printer interface board (PEI01A board) after
installation of FN-PS551 application and key registry is complete.
(1)
Switch off the power to the control unit.
(2)
Install the printer interface board in the control unit, then connect the printer
interface cable.
(3)
Turn on the control unit power.
(4)
The FN-PS551 application starts, exit from the FN-PS551 application by
clicking [Exit] on the [Exit] menu in the [FN-PS551] window or clicking the
close box
(5)
When the [Found New Hardware Wizard] screen is displayed, click [Next] as
default setting.
(6)
When the [Completing the Found New Hardware Wizard] message is
displayed, click [Finish].
REFERENCE
Following the above mentioned procedure, the printer interface board will be
properly recognized.
(7)
From the [start] menu on the Windows desktop, click [All Programs], [Fuji
Photo Film], and then [FN-PS551Appl] to restart the FN-PS551 application.
(8)
Carry out [Test Print] from the [Utility] menu on the [FN-PS551] window and
print image output from a client to check that printing is output properly.
NOTE
Various configuration items of FN-PS551 should be reset before checking
the operation. Check for the operation of printer and client should be
completed beforehand.
006-251-07
10.28.2002 FM3487
in the top right-hand corner of the window.
Maintenance-295
FN-PS551 Service Manual Maintenance-295
Advertisement
Chapters
Table of Contents
