Table of Contents
Advertisement
Appendix
Chapter 1. Network Installation Specification
Formatting and Copying a Floppy Disk
Use the Diagnostic FD to copy and format a floppy disk.
1. Formatting a Floppy Disk
Step 1:
Connect a CRT terminal to the port P1 of the router. Then, insert the Diagnostic FD into
the floppy disk drive, and power ON.
Step 2:
The following messages appear. Type in test command "10" and hit the [CR] key.
(test command)
0 automatic mode
1 timer test
2 led test
3 memory test
4 dma test
5 interrupt test
6 c/s register test
7 serial I/O test
8 fdc test
9 IEEE802.3 test
10 FD format
11 FD diskcopy
61 IIF board test
(TOP)
DIAG>
Step 3:
When prompted, remove the Diagnostic FD from the floppy disk drive. Checking that
the write-protect tab of a 3.5-inch 2HD floppy disk to be formatted is write-enabled,
insert the floppy disk and then hit the [Y] and [CR] keys.
DIAG>10 [CR]
FD format
please insert new fld and [Y/N]: Y [CR]
006-251-00
10.30.98 FM2327
top menu
Appendix-14
FN-PS551 Service Manual
Appendix-14
Advertisement
Chapters
Table of Contents
