Maintenance 7. Service Utility
(4)
Change to the next floppy disk for collecting analysis information and click
[OK].
→ "Copying" message appears again and analysis information is stored on the floppy
disk.
(5)
When the next disk becomes full the message shown in (3) appears. Change
to the next floppy disk for collecting analysis information, and repeat step (4).
Repeat these steps until the message mentioned in (6) appears.
(6)
When copying of analysis information to floppy disk is complete, one of the
messages shown below will appear.
→ Copy completion message when no image data is present in output cue.
→ Copy completion message when image data is present in output cue.
(7)
Click [OK] and remove the floppy disk for collecting analysis information from
the floppy disk drive.
(8)
Click [Cancel] in dialog for selection of file to be acquired and specifications
of transferred file to finish collection of analysis information.
006-251-05
05.30.2001 FM3069
Maintenance-138
FN-PS551 Service Manual Maintenance-138