Table of Contents
Advertisement
Maintenance 9. Setting the Control Unit (PC) to Use PEI01A Board
(8)
After checking that [Save Changes and Exit] is selected on the termination
window of the setup utility (BOIS), which is displayed by pressing <Esc> key
twice, then press <Enter> key.
REFERENCE
If no settings are changed during confirmation, termination window is not
displayed and the setup utility (BIOS) finishes automatically.
→ The setup utility (BIOS) finishes and the system restarts.
(9)
After restart is complete, perform shutdown procedures, and switch off the
power to the control unit and monitor.
(10) Reinstall the PEI boards in the control unit.
006-251-06
12.18.2001 FM3271
Maintenance-263
FN-PS551 Service Manual Maintenance-263
Advertisement
Chapters
Table of Contents
