Installation
2. Setting Up the Equipment
For GX150/GX260 Series Control Unit
Remove the Control Main Unit Cover
Press and hold in the two buttons on the left and right sides of the control unit as
illustrated, and swing the cover up and forward till it stops at a vertical position.
Remove the Expansion Card Cage
Lift up the expansion card cage by holding the card cage fitting handle, and remove it
from the chassis.
Install the E-I/F Board
Install the E-I/F board in the PCI bus slot of the expansion card cage riser board
(expansion slot board).
• Slot layout on the riser board (expansion slot board)
(For DELL OptiPlex GX150/GX260 series control unit models)
006-251-07
10.28.2002 FM3487
Control main unit cover
Expansion card cage
F R
O N
T
T
O N
F R
Button
FP4B0078.EPS
Fitting handle
FP4B0079.EPS
PCI1 (first PEI board)
PCI2 (second PEI board)
FN-PS551 Service Manual Installation-23
Installation-23
FP4B0080.EPS