Table of Contents
Advertisement
Maintenance 7. Service Utility
(1)
To add or modify a protocol, set the following parameters.
• [Timeout]:
Three timeout values can be specified in the range of 30 to 3,600 seconds
(the default value is 600 seconds).
Normally the default for the timeout should be used.
• [command timeout:] (timeout for interval between commands):
• [data transfer timeout:] (timeout for image data transfer):
• [store to store timeout:] (timeout between stores):
• [Connection error handling]:
Specifies how to handle image data in a film received before connection has
broken halfway during transmission (the default value is printed).
Normally the default for the connection error handling should be used.
However, it can be changed if the relevant user specifically does not need to
print only received image data until the connection error has occurred.
• [thrown away]: Received data is discarded.
• [printed]: Received data alone is printed.
(2)
Set the parameters and click [OK].
→ The [Protocols] window on the [SERVICE UTILITY] window reappears.
006-251-03
03.30.2000 FM2730
Specifies the maximum time from the beginning of a given command
transfer to the beginning of the next command transfer in the course of
a series of communication process.
Specifies the maximum time for transferring image data.
Specifies the maximum time from the end of a given frame transfer to
the beginning of the next frame transfer in a single film.
Maintenance-55
FN-PS551 Service Manual Maintenance-55
Advertisement
Chapters
Table of Contents
