Starting Up; Turning On The Unit - FujiFilm FN-PS551 Service Manual

Installation

3. Starting up

3. Starting Up
3.1

Turning ON the Unit

(1) Turn on the Power switch of the monitor and then that of the control unit.
→ After the system boots up, the FN-PS551 application starts, and the [FN-PS551]
window appears.
NOTE
The [FN-PS551] window is pre-set at the factory to English-language display.
To change the display language, run the system operation check, then follow
the instructions given in "8. Setting the Language for FN-PS551 Application".
(2) Click the [Version] menu on the menu bar, and check that the installed key
registry (DICOM, TOSHIBA or IPU) is correctly displayed in the [Version]
message.
→ The following is displayed when the key registry for the DICOM protocol is
installed:
006-251-06
12.18.2001 FM3271
Installation-32
FN-PS551 Service Manual Installation-32