FujiFilm FN-PS551 Service Manual page 297

Maintenance 10. Installing Software for GX150 Series Control Unit
(11) [Insert Disk] appears on the screen after restarting, then insert the
"Reinstallation CD" in the CD-ROM drive and click [OK].
(12) [Windows NT Setup] wizard appears, so enter the necessary information
following the instructions displayed on the screen.
• For Setup Options, choose [Typical].
• For Name and Organization, type "fieldengineer" in the [Name:]
• For Registration, enter the Product ID attached to the control main unit.
• For Computer Name, enter a computer name (host name, e.g., FN-
NOTE
• The computer name (host name) must be entered in single-byte
alphanumeric characters.
• The computer name (host name) is displayed in upper case once entered
in either lower case or upper case.
• For the FUJI protocol (FINP), the maximum length of computer name
(host name) is limited to 10 characters. For other protocols, it is limited to
15 characters.
• The computer name (host name) must be a unique name within the
installation site. If more than one FN-PS551 is used in the same installation
site, each unit must be given a different name.
• For Administrator Account, type the password character string "pc-ps"
• For Emergency Repair Disk, choose [No, do not create an emergency
• For Windows NT Components, choose [Install the most common
• On the network participation method selection screen, choose [Do not
• On the Windows NT setup completion screen, click [Finish].
(13) For [Data/Time Properties] dialog, check that [Time Zone] and [Date & Time]
are correct (readjust if they are wrong), then click [Close].
(14) [Detected Display] message appears, so click [OK].
(15) [Display Properties] dialog appears, so click [OK].
(16) [Windows NT 4.00 has been installed successfully.] appears on the screen,
so remove the CD-ROM from the drive, then click [Restart Computer].
(17) On the operating system selection screen displayed after restarting, check
that "Windows NT Workstation Version 4.00" is highlighted, then press <Enter>
key.
006-251-06
12.18.2001 FM3271
field and "FUJIFILM" in the [Organization:] field.
PS551) in the [Name] field.
in lower case in both the [Password:] and [Confirm Password:] fields.
repair disk.] because a repair disk is not to be created.
components (recommended).].
connect this computer to a network at this time.].
Maintenance-268
FN-PS551 Service Manual Maintenance-268