Table of Contents
Advertisement
Installation
2. Setting Up the Equipment
NOTE
For DELL OptiPlex GX150/GX260 series control unit (PC) models, expansion
slots are constructed only on PCI bus, so a DXA01A board can not be used.
In this case, use a PEI01A board.
(1)
Pull up the lever to the outside of the slot.
(2)
Remove the metal bracket covering the opening for the expansion card slot
to be used.
(3)
Insert the E-I/F board card edge connector into the riser board expansion
card connector firmly but gently.
Expansion card cage
(4)
Push down the lever and fix the E-I/F board onto the expansion card cage.
006-251-07
10.28.2002 FM3487
Bracket
Lever
Expansion card cage
Card edge connector
FP4B0081.EPS
E-I/F board
Riser board
Expansion card connector
FN-PS551 Service Manual Installation-24
Installation-24
FP4B0082.EPS
Advertisement
Chapters
Table of Contents
