Show Mep-Alarm Status - Allied Telesis x510-28GTX Command Reference Manual

C F M
ONNECTIVITY AULT ANAGEMENT
-
SHOW MEP ALARM STATUS

show mep-alarm status

Overview Use this command to show any alarms that have been declared by Local MEPs, and
the defect(s) that caused the alarm.
show mep-alarm status
Syntax
Mode User Exec/Privileged Exec
Usage A Local MEP is used to detect connectivity faults with other remote MEPs that are
in the same Maintenance Association (MA) and Maintenance Domain (MD) as the
Local MEP. A Local MEP looks first for connectivity defects, and if these defects
persist for a long enough period of time (typically 2.5 seconds), then an alarm is
declared.
Example To show the alarms on local MEPs, use the command:
awplus#
Output Figure 9-13: Example output from show mep-alarm status
Table 9-9: Parameters in the output from show mep-alarm status
Related ethernet cfm mep
Commands
mep (FNG attributes)
mep crosscheck
Command Version 5.4.7-1.1: command added
changes
C613-50170-01 Rev B
C
OMMANDS
show mep-alarm status
awplus#show mep-alarm status

CFM Domain Name
------------------------------------------------------------------
MD-INST1
Parameter
CFM Domain Name
CFM Service Name
Active Alarms
MEP
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
CFM Service Name
MA-INST1-1
Description
The domain name.
The MA name.
The highest priority defect causing the alarm, one of the
following: someRDI, someMACstatus, someRMEPCCM,
errorCCM, or xconCCM.
The local MEP's ID.
MEP Active Alarm
12 someRMEPCCM
368