Table of Contents
Advertisement
A
M
C
LARM
ONITORING
OMMANDS
SHOW ALARM FACILITY STATUS
show alarm facility status
Overview
Use this command to view alarms on the switch.
With the all parameter, the output lists all alarm sources that are currently in a fault
state, even if there is no alarm configured for them.
Without the all parameter, the output only lists alarm sources that are currently in
a fault state and have an alarm configured for them.
show alarm facility status [all]
Syntax
Mode
User Exec and Privileged Exec
Example
To display the currently active alarms on the switch, use the command:
awplus#
Output
Figure 14-2: Example output from the show alarm facility status command
Related
show alarm facility settings
commands
Command
Version 5.4.9-1.1: command syntax changed from show facility-alarm status to
changes
show alarm facility status
C613-50644-01 Rev B
Parameter
all
show alarm facility status
Active alarms
----------------------
External PSU
EPSR
Link down
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
Display every alarm source that is in a fault state at
this point of time.
ID
---------
2
-
port1.0.1
506
Advertisement
Table of Contents
