Table of Contents
Advertisement
VACON® 3000
Application Guide
1.
Select language (P6.1).
If a battery is installed, the steps 2–5 are shown.
2.
Set daylight saving time (P5.5.5). (Russia, US, EU, or OFF)
3.
Set time (P5.5.2).
4.
Set year (P5.5.4).
5.
Set date (P5.5.3).
6.
Run start-up wizard?
If the selection is No, the start-up wizard ends.
7.
Set a value for P3.1.2.2 Motor Type (so that it agrees with the nameplate).
8.
Set a value for P3.1.1.1 Motor Nominal Voltage (so that it agrees with the nameplate).
9.
Set a value for P3.1.1.2 Motor Nominal Frequency (so that it agrees with the nameplate).
10.
Set a value for P3.1.1.3 Motor Nominal Speed (so that it agrees with the nameplate).
11.
Set a value for P3.1.1.4 Motor Nominal Current.
12.
Set a value for P3.1.1.5 Motor Cos Phi.
13.
Set a value for P3.3.1.1 Minimum Frequency Reference.
14.
Set a value for P3.3.1.2 Maximum Frequency Reference.
15.
Set a value for P3.4.1.2 Acceleration Time 1.
16.
Set a value for P3.4.1.3 Deceleration Time 1.
After these selections, the start-up wizard is completed. To start the start-up wizard again, go to the parameter B6.5.1 Restore Facto-
ry Defaults.
1.5.2 Start-Up Wizard for AFE
The start-up wizard tells you to give necessary data for the drive to control your procedure.
Procedure
1.
Select language (P6.1).
If a battery is installed, the steps 2–5 are shown.
2.
Set daylight saving time (P5.5.5). (Russia, US, EU, or OFF)
3.
Set time (P5.5.2).
4.
Set year (P5.5.4).
5.
Set date (P5.5.3).
After these selections, the start-up wizard is completed. To start the start-up wizard again, go to the parameter B6.5.1 Restore Facto-
ry Defaults.
Danfoss A/S © 2021.09
Introduction
AB319735759636en-000101 / DPD01822 | 11
Advertisement
Table of Contents
