Danfoss VACON 3000 Application Manual page 218

VACON® 3000
Application Guide
Use this parameter to set the fault limit for the maintenance counter. When the value of the counter goes above this limit, a mainte-
nance fault occurs.
7.242 (ID 1107) Counter 1 Reset
Location in the menu: P3.11.4
Use this parameter to reset the maintenance counter.
7.243 (ID 1195) FUNCT Button Configuration
Location in the menu:
• INU application: P3.11.5
• AFE application: P3.10.5
• BCU application: P3.8.5
Use this parameter to set the values of the FUNCT button. The values that you set with this parameter will be available when you
push the FUNCT button on the keypad.
7.244 (ID 1196) Multimonitor View
Location in the menu:
•
INU application: P3.11.4
• AFE application: P3.10.4
Use this parameter to set the division of the display of the control panel into sections in the multimonitor view.
7.245 (ID 1197) C/F Selection
Location in the menu:
• INU application: P3.11.2
• AFE application: P3.10.2
•
BCU application: P3.8.2
Use this parameter to set the temperature measuring unit. The system shows all the temperature-related parameters and monitor-
ing values in the set unit.
7.246 (ID 1198) KW/HP Selection
Location in the menu:
• INU application: P3.11.3
• AFE application: P3.10.3
• BCU application: P3.8.3
Use this parameter to set the power measuring unit. The system shows all the power-related parameters and monitoring values in
the set unit.
7.247 (ID 1201) Set Supply Voltage
Location in the menu: P3.1.3.12
Use this parameter to set the supply voltage value.
7.248 (ID 1210) Mechanical Brake Feedback
•
Location in the menu: P3.5.1.30 (In I/O Configuration menu)
• Location in the menu: P3.14.8 (In Mechanical Brake menu)
Use this parameter to set the brake status feedback signal from mechanical brake. The Brake feedback signal is used if the value for
parameter P3.14.1 is Enabled with brake status supervision.
Connect this digital input signal to an auxiliary contact of the mechanical brake.
• The contact is open = the mechanical brake is closed.
• The contact is closed = the mechanical brake is open.
218 | Danfoss A/S © 2021.09
Parameter descriptions
AB319735759636en-000101 / DPD01822