Danfoss VACON 3000 Application Manual page 265

VACON® 3000
Application Guide
Selection Selection name
number
0 Not used
1 TEST (Always closed)
2 Ready
3 Run
4 General fault
5 General fault inverted
6 General alarm
7 Reversed
8 At speed
9 Thermistor fault
10 Motor regulator activated
11 Start signal active
12 Keypad control active
13 I/O control B active
14 Limit supervision 1
15 Limit supervision 2
16 Jogging active
17 Preset Frequency active
18 Quick Stop active
19 PID in Sleep mode
20 Fieldbus Control Word bit 13
21 Fieldbus Control Word bit 14
22 Fieldbus Control Word bit 15
23 Fieldbus Process Data In1 bit 0
24 Fieldbus Process Data In1 bit 1
25 Fieldbus Process Data In1 bit 2
26 Mechanical brake control
27 Mechanical brake control (Inverted)
28 Motor Switch Open
29 Main contactor permissive
Danfoss A/S © 2021.09
Description
The output is not used.
The AC drive is ready to operate.
The AC drive operates (the motor runs).
A fault trip occurred.
A fault trip did not occur.
An alarm occurred.
The reverse command is given.
The output frequency has become the same as the set frequency reference.
A thermistor fault occurred.
One of the limit regulators (for example current limit or torque limit) is acti-
vated.
The start command of the drive is active.
The selection is keypad control (the active control place is keypad).
The selection is I/O control place B (the active control place is I/O B).
The limit supervision activates if the signal value goes below or above the
set supervision limit (P3.8.3 or P3.8.7).
The limit supervision activates if the signal value goes below or above the
set supervision limit (P3.8.3 or P3.8.7).
The Jogging function is active.
The selection of preset frequency was made with digital input signals.
The Quick stop function is activated.
The PID controller is in the sleep mode.
The digital (relay) output control from the Fieldbus control word bit 13.
The digital (relay) output control from the Fieldbus control word bit 14.
The digital (relay) output control from the Fieldbus control word bit 15.
The digital (relay) output control from the Fieldbus Process Data In1, bit 0.
The digital (relay) output control from the Fieldbus Process Data In1, bit 1.
The digital (relay) output control from the Fieldbus Process Data In1, bit 2.
The Open mechanical brake command.
The Open mechanical brake command (inverted).
The Motor Switch function has detected that the switch between the drive
and the motor is open.
The permission to close the main contactor is given.
Parameter descriptions
AB319735759636en-000101 / DPD01822 | 265