Danfoss VACON 3000 Application Manual page 310

VACON® 3000
Application Guide
Example
The value 1a 143d 02:21 is received from the operating time counter from the fieldbus.
• ID1754: 1 (years)
• ID1755: 143 (days)
• ID1756: 2 (hours)
• ID1757: 21 (minutes)
• ID1758: 0 (seconds)
8.3.2 Operating Time Trip Counter
The operating time trip counter of the control unit can be reset. It is in the submenu Trip counters. It is possible to reset the counter
with the PC, the control panel, or the fieldbus. The value of the counter has 5 different 16-bit values. To read the value of the coun-
ter through fieldbus, use these ID numbers.
ID number
ID 1766
ID 1767
ID 1768
ID 1769
ID 1770
Example
The value 1a 143d 02:21 is received from the operating time trip counter from the fieldbus.
• ID1766: 1 (years)
• ID1767: 143 (days)
• ID1768: 2 (hours)
• ID1769: 21 (minutes)
• ID1770: 0 (seconds)
ID number
ID 2311
To reset the energy trip counter, use the PC, the control panel, or the fieldbus. When using the PC or the control panel, reset the
counter in the Diagnostics menu. When using the fieldbus, set a rising edge to ID 2311 Operating Time Trip Counter Reset.
8.3.3 Run Time Counter
The run time counter of the motor cannot be reset. It is in the submenu Total counters. The value of the counter has 5 different 16-
bit values. To read the value of the counter through fieldbus, use these ID numbers.
ID number
ID 1772
ID 1773
ID 1774
ID 1775
ID 1776
310 | Danfoss A/S © 2021.09
Counter value
Operating Time Trip Counter (years)
Operating Time Trip Counter (days)
Operating Time Trip Counter (hours)
Operating Time Trip Counter (minutes)
Operating Time Trip Counter (seconds)
Counter value
Operating Time Trip Counter Reset
Counter value
Run Time Counter (years)
Run Time Counter (days)
Run Time Counter (hours)
Run Time Counter (minutes)
Run Time Counter (seconds)
Fault tracing
AB319735759636en-000101 / DPD01822