Danfoss VACON 3000 Application Manual page 153

VACON® 3000
Application Guide
6.125 (ID 3586) Enclosure Humidity and Temperature
Location in the menu:
• INU application: V2.6.18
• AFE application: V2.6.14
This monitoring value shows 16-bit word where each bit is the status of one digital input from humidity or temperature measure-
ment.
6.126 (ID 4500) Motor Speed Filtered
Location in the menu:
• Standard application: V2.6.14
This monitoring value shows the motor speed in RPM.
6.127 (ID 4501) FB Speed Actual Signed
Location in the menu:
•
Standard application: V2.8.7
This monitoring value shows the actual speed of the drive as a percentage of minimum frequency and maximum frequency. The
value -100% indicates the minimum frequency and the value 100% indicates the maximum frequency. This monitoring value is con-
tinuously updated depending on the momentary min and max frequencies and the output frequency.
6.128 (ID 4502) Output Filter Status Word
Location in the menu:
•
Standard application: V2.6.19
This monitoring value shows 16-bit word where each bit is the status of one digital input from a temperature or pressure measure-
ment of an output filter.
6.129 (ID 4503) Motor Torque LP 16
Location in the menu:
• Standard application: V2.6.20
This monitoring value shows the calculated shaft torque with a 16 ms low-pass filter.
6.130 (ID 4504) Motor Torque Unfilt
Location in the menu:
•
Standard application: V2.6.21
This monitoring value shows the calculated shaft torque unfiltered.
6.131 (ID 5510) Line Voltage
Location in the menu:
• AFE application: V2.3.2.1
This monitoring value shows the measured line voltage.
6.132 (ID 5511) Line Frequency
Location in the menu:
•
AFE application: V2.3.2.2
This monitoring value shows the measured line frequency.
6.133 (ID 5512) Line PLL Locked
Location in the menu:
• AFE application: V2.3.2.3
This monitoring value shows if the line PLL is locked.
Danfoss A/S © 2021.09
Monitoring value descriptions
AB319735759636en-000101 / DPD01822 | 153