Danfoss VACON 3000 Application Manual page 147

VACON® 3000
Application Guide
• Standard application: V2.10.3.2
This monitoring value shows the number of glitches detected by the input encoder in channel A. The glitches are usually caused by
electromagnetic interference
6.71 (ID 3052) Encoder Error Flags
Location in the menu:
•
Standard application: V2.10.3.3
This monitoring value shows the error type in the encoder channel A.
6.72 (ID 3053) Frequency Error
Location in the menu:
• Standard application: V2.10.3.4
This monitoring value shows the difference between the motor model frequency and the frequency of the encoder in channel A.
6.73 (ID 3054) Encoder Direction
Location in the menu:
• Standard application: V2.10.3.5
This monitoring value shows the hysteresis filtered rotation direction state of the encoder in channel A.
6.74 (ID 3055) Encoder Electrical Frequency
Location in the menu:
• Standard application: V2.10.3.6
This monitoring value shows the electrical frequency of the encoder in channel A.
6.75 (ID 3056) Encoder Mechanical Frequency
Location in the menu:
• Standard application: V2.10.3.7
This monitoring value shows the mechanical frequency of the encoder in channel A.
6.76 (ID 3057) Encoder Electrical Angle
Location in the menu:
•
Standard application: V2.10.3.8
This monitoring value shows the electrical angle of the encoder in channel A.
6.77 (ID 3058) Encoder Mechanical Angle
Location in the menu:
• Standard application: V2.10.3.9
This monitoring value shows the mechanical angle of the encoder in channel A.
6.78 (ID 3059) Revolutions
Location in the menu:
•
Standard application: V2.10.3.10
This monitoring value shows the mechanical revolutions count of the encoder in channel A.
6.79 (ID 3060) Encoder Update Position
Location in the menu:
• Standard application: V2.10.3.11
This monitoring value shows the position counter at the last pulse of the encoder in channel A.
Danfoss A/S © 2021.09
Monitoring value descriptions
AB319735759636en-000101 / DPD01822 | 147