Danfoss VACON 3000 Application Manual page 140

VACON® 3000
Application Guide
6.31 (ID 74) Last Active Alarm Code
Location in the menu:
• INU application: V2.6.11
• AFE application: V2.6.8
This monitoring value shows the alarm code of latest activated alarm that is not reset.
6.32 (ID 75) Analog Input 5
Location in the menu:
• INU application: V2.4.8
• AFE application: V2.4.8
This monitoring value shows the value of the analog input signal as a percentage of the used range.
6.33 (ID 76) Analog Input 6
Location in the menu:
• INU application: V2.4.9
• AFE application: V2.4.9
This monitoring value shows the value of the analog input signal as a percentage of the used range.
6.34 (ID 77) Motor Regulator Status
Location in the menu:
• Standard application: V2.6.13
This monitoring value shows the bit-coded status of the motor limit controllers.
The values are visible as checkboxes on the graphical display. If a box is selected, the limit controller is active.
6.35 (ID 78) Ready Status
Location in the menu:
• INU application: V2.6.2
• AFE application: V2.6.2
This monitoring value shows the bit-coded data about the Ready criteria of the drive. This data is useful for monitoring when the
drive is not in the Ready state.
The values are visible as checkboxes on the graphical display. If a box is selected, the value is active.
6.36 (ID 79) Output Power
Location in the menu:
• Standard application: V2.1.8 and V2.3.14
This monitoring value shows the output power in kW.
6.37 (ID 81) SlotA AO 1
Location in the menu:
•
INU application: V2.4.10
•
AFE application: V2.4.10
• BCU application: V2.3.6
This monitoring value shows the value of the analog output as a percentage of the used range.
140 | Danfoss A/S © 2021.09
N O T I C E
N O T I C E
Monitoring value descriptions
AB319735759636en-000101 / DPD01822