Danfoss VACON 3000 Application Manual page 205

VACON® 3000
Application Guide
7.176 (ID 727) Undervoltage Fault
Location in the menu:
• INU application: P3.9.1.3
• AFE application: P3.8.1.3
• BCU application: P3.6.1.3
Use this parameter to select if undervoltage faults are saved to the fault history or not.
7.177 (ID 731) Automatic Reset
Location in the menu:
• INU application: P3.10.1
• AFE application: P3.9.1
• BCU application: P3.7.1
Use this parameter to enable the Automatic reset function. To select the faults that are reset automatically, enter the value 0 or 1 to
parameters ID 720–726 and ID 738.
The automatic reset function is available only for some fault types.
7.178 (ID 732) Thermistor Fault
Location in the menu:
• INU application: P3.9.1.7
• AFE application: P3.8.1.7
• BCU application: P3.6.1.7
Use this parameter to select the response of the drive to a 'Thermistor' fault. If the thermistor detects too high temperature, a ther-
mistor fault occurs. See ID 701.
7.179 (ID 733) Response to Fieldbus Communication Fault
Location in the menu:
• INU application: P3.9.1.5
• AFE application: P3.8.1.5
• BCU application: P3.6.1.5
Use this parameter to select the response of the drive to a fieldbus communication fault. If the data connection between the master
and the fieldbus board is defective, a fieldbus fault occurs.
7.180 (ID 734) Slot Communication Fault
Location in the menu:
• INU application: P3.9.1.6
• AFE application: P3.8.1.6
• BCU application: P3.6.1.6
Use this parameter to select the response of the drive to a 'Slot Communication' fault. If the drive detects a defective option board, a
slot communication fault occurs. See ID 701.
7.181 (ID 738) Autoreset: Underload Fault
Location in the menu:
•
INU application: P3.10.13
• AFE application: P3.9.13
Use this parameter to enable the automatic reset after an underload fault.
Danfoss A/S © 2021.09
N O T I C E
Parameter descriptions
AB319735759636en-000101 / DPD01822 | 205