The Start-Up Wizard For Open-Loop Applications - Danfoss VLT FC 101 Quick Manual

Quick Guide
1 1
At power-up
At the first power-up, the user is asked to choose the
preferred language. Once selected, this screen will never
be shown again in the following power-ups, but the
language can still be changed in 0-01 Language.
Figure 1.27
1.4.3 The Start-up Wizard for Open-loop
Applications
The built-in "wizard" menu guides the installer through the
setup of the drive in a clear and structured manner in
order to set up an open-loop application. An open-loop
application is here an application with a start signal,
analog reference (voltage or current) and optionally also
relay signals (but no feedback signal from the process
applied).
Figure 1.28
The wizard will initially be shown after power-up until any
parameter has been changed. The wizard can always be
accessed again through the Quick Menu. Press [OK] to start
the wizard. If [BACK] is pressed, the FC101 will return to
the status screen.
Figure 1.29
1-20
VLT HVAC Basic Drive Quick Guide
Select Language
[ 0 ] English
Set-up 1
FC
12
+24V
DIG IN
18
Start
19
DIG IN
20
COM DIG IN
27
DIG IN
29
DIG IN
+10V
50
+
A IN
53
Reference
A IN
54
COM
55
-
42
A OUT / D OUT 0-10 V
45
A OUT / D OUT
01
02
03
04
05
06
Press OK to start Wizard
Push Back to skip it
Set-up 1
MG18A322 - VLT
®
is a registered Danfoss trademark