Danfoss VACON 3000 Application Manual page 257

VACON® 3000
Application Guide
Use this parameter to set the supply network voltage measurement type for channel B.
7.545 (ID 5023) Grid Voltage Feedback Channel C
Location in the menu:
• AFE application: P3.1.1.6
Use this parameter to set the supply network voltage measurement type for channel C.
7.546 (ID 5024) Grid Voltage Feedback Scale
Location in the menu:
•
AFE application: P3.1.1.7
Use this parameter to set the nominal secondary voltage of the potential transformer.
7.547 (ID 5030) Filter Topology
Location in the menu:
• AFE application: P3.1.1.8
Use this parameter to set the input filter type (LCL or LC).
7.548 (ID 5039) Regen Filter Select
Location in the menu:
• INU application: P3.1.2.9.1
•
AFE application: P3.1.1.9
Use this parameter to set the AFE power unit type for the regen filter.
7.549 (ID 5040) Special Filter Index
Location in the menu:
• INU application: P3.1.2.9.2
• AFE application: P3.1.1.10
Use this parameter to set the special filter index value.
7.550 (ID 5053) Virtual LCCL Mix
Location in the menu:
•
AFE application: P3.2.4.5
Use this parameter to set the virtual LCCL mix value in percent.
7.551 (ID 5054) Active Damp Resistance
Location in the menu:
• INU application: P3.1.2.9.3
• AFE application: P3.2.4.1
Use this parameter to set the quantity of virtual resistance damping. Give the value in % of the system base impedance.
7.552 (ID 5055) Active Damp Cutoff Frequency
Location in the menu: P3.1.2.9.4
Use this parameter to set the active damping cutoff frequency in Hz.
7.553 (ID 5060) Line PLL Gain
Location in the menu:
•
AFE application: P3.2.5.1
Use this parameter to set the gain value for the line PLL.
Danfoss A/S © 2021.09
Parameter descriptions
AB319735759636en-000101 / DPD01822 | 257