Danfoss VACON 3000 Application Manual page 130

VACON® 3000
Application Guide
Index Parameter
5.7.6 Keypad
Table 183: The Keypad Parameters in the I/O and Hardware Menu
Index Parameter Min
P5.7.1 Timeout 0
Time
P5.7.2 Default 0
Page
P5.7.3 Menu Index
P5.7.4 Contrast 30
P5.7.5 Backlight 0
Time
5.7.7 Fieldbus
In the I/O and Hardware menu, there are the parameters that are related to fieldbus boards. You can find the instructions on how to
use these parameters in the related fieldbus manual.
Table 184: Fieldbus Menu Structure
Submenu level 1
RS-485
Ethernet
130 | Danfoss A/S © 2021.09
Min Max Unit
Max Unit De- ID
fault
60 min 0 804
4 0 2318
2499
70 % 50 830
60 min 5 818
Submenu level 2
Common settings
Common settings
Default ID Description
1 = Enabled
Description
The time after which the display goes back to the page that is set
with parameter P5.7.2.
0 = Not used
The page that the display shows when the drive is powered up, or
when the time that is set with P5.7.1 is expired. If the value is set to
0, the display shows the last page that it showed.
0 = None
1 = A menu index
2 = Main menu
3 = Control page
4 = Multimonitor
Set a page to be the menu index. (The selection 1 in P5.7.2.)
Set the contrast of the display.
Set the time after which the backlight of the display turns off. If the
value is set to 0, the backlight is always on.
Submenu level 3
Protocol
IP address mode
Duplicate IP detect
Speed/Duplex
Ethernet Fieldbus 1
Ethernet Fieldbus 2
Fixed IP
Speed/Duplex
IP address
AFE Application
Submenu level 4
IP address
Subnet mask
Default gateway
AB319735759636en-000101 / DPD01822