Danfoss VACON 3000 Application Manual page 309

VACON® 3000
Application Guide
8.2.63 Fault Code 205 - Coolant Temperature
8.2.63.1 Fault Code 205, ID 1745 - Coolant Temperature
Cause
• Coolant temperature ≥ 70.0 °C (158 °F).
Troubleshooting
• –
8.2.63.2 Fault Code 205, ID 1745 - Coolant Temperature
Cause
• Coolant temperature ≤ -10.0 °C (14 °F).
Troubleshooting
• –
8.2.64 Fault Code 300 - Unsupported
8.2.64.1 Fault Code 300, ID 700 - Unsupported
Cause
• The application is not compatible (it is unsupported).
Troubleshooting
• Replace the application.
8.2.64.2 Fault Code 300, ID 701 - Unsupported
Cause
• The option board or the slot is not compatible (it is unsupported).
Troubleshooting
• Remove the option board.
8.3 Total and Trip Counters
The AC drive has different counters based on the operation time of the drive and the energy consumption. Some of the counters
measure total values and some can be reset.
The energy counters measure the energy that is taken from the supply network. The other counters are used to measure, for exam-
ple, the operation time of the drive or the run-time of the motor.
It is possible to monitor all the counter values from the PC, control panel, or fieldbus. When using the PC or the control panel, it is
possible to monitor the counter values in the Diagnostics menu. When using fieldbus, it is possible to read the counter values with
the ID numbers.
8.3.1 Operating Time Counter
Resetting: not possible
Location: submenu Total counters
The value of the counter has 5 different 16-bit values. To read the value of the counter through fieldbus, use these ID numbers.
ID number
ID 1754
ID 1755
ID 1756
ID 1757
ID 1758
Danfoss A/S © 2021.09
Counter value
Operating Time Counter (years)
Operating Time Counter (days)
Operating Time Counter (hours)
Operating Time Counter (minutes)
Operating Time Counter (seconds)
Fault tracing
AB319735759636en-000101 / DPD01822 | 309