Danfoss VACON 3000 Application Manual page 117

VACON® 3000
Application Guide
Index Parameter
P3.5.2.10.3 AI10 Signal Range
P3.5.2.10.4 AI10 Custom. Min
P3.5.2.10.5 AI10 Custom. Max
P3.5.2.10.6 AI10 Signal Inversion
Shows only the parameters for the outputs on option boards in slots C, D, and E. Make the selections as in RO1 Function
(P3.5.3.2.1). This group or these parameters are not visible if there are no digital outputs in slots C, D, or E.
Table 160: Digital Output Settings on Standard I/O Board
Index Parameter
P3.5.3.2.1 RO1 Func-
tion
Danfoss A/S © 2021.09
Min
0
-160.00
-160.00
0
N O T I C E
Min Max Unit De-
fault
0 40 29
Max Unit Default
1 0
160.00 % 0.00
160.00 % 100.00
1 0
ID Description
11001 0 = Not used
1 = Test (always closed)
2 = Ready
3 = Run
4 = Fault
5 = Fault inverted
6 = Alarm
7 = Reverse
8 = At speed
9 = Thermistor fault
10 = Motor regulator active
11 = Start signal active
12 = Keypad control active
14 = Limit supervision1
15 = Limit supervision2
20 = Fieldbus Control- Word B13
21 = Fieldbus Control- Word B14
22 = Fieldbus Control- Word B15
23 = Fieldbus Process- Data1.B0
24 = Fieldbus Process- Data1.B1
25 = Fieldbus Process- Data1.B2
29 = Mains contactor permissive
30 = Mains contactor close
31 = Precharge permissive
32 = INU run enable
33 = Precharge ready
34 = Precharge started
35 = Precharge inhibit
36 = Precharge coil
37 = HXL coil
38 = MV HX coil
39 = LV HX coil
AFE Application
ID Description
5632 See P3.5.2.1.3.
5633 See P3.5.2.1.4.
5634 See P3.5.2.1.5.
5635 See P3.5.2.1.6.
AB319735759636en-000101 / DPD01822 | 117