Table of Contents
Advertisement
VACON® 3000
Application Guide
6 Monitoring value descriptions
6.1 (ID 1) Output Frequency
Location in the menu:
•
Standard application: V2.1.2 and V2.3.1
•
AFE application: V1.2.5
This monitoring value shows the actual output frequency to the motor.
6.2 (ID 2) Motor Speed
Location in the menu:
•
Standard application: V2.1.4 and V2.3.3
This monitoring value shows the actual speed of the motor in RPM (calculated value).
6.3 (ID 3) Motor/Total Current
Location in the menu:
•
INU application: V2.1.3 and V2.3.4
•
BCU application: V2.2.1
In the INU application, this parameter is named Motor Current, and shows the measured current of the motor.
In the BCU application, this parameter is named Total Current, and shows the measured current of the BCU.
6.4 (ID 4) Motor Torque
Location in the menu:
•
Standard application: V2.1.5 and V2.3.5
This monitoring value shows the actual torque of the motor (calculated value).
When the torque is in counterclockwise direction, the value is negative.
6.5 (ID 5) Motor Shaft Power
Location in the menu:
•
Standard application: V2.1.6 and V2.3.7
This monitoring value shows the actual shaft power of the motor (calculated value) as a percentage of the motor nominal power.
6.6 (ID 6) Motor Voltage
Location in the menu:
•
Standard application: V2.1.7 and V2.3.9
This monitoring value shows the actual output voltage to the motor.
6.7 (ID 7) DC-link Voltage
Location in the menu:
•
INU application: V2.1.9 and V2.3.10
•
AFE application: V2.1.1 and V2.3.1.1
•
BCU application: V2.1.2 and V2.2.3
This monitoring value shows the measured voltage in the DC link of the drive.
6.8 (ID 8) Unit Temperature
Location in the menu:
•
INU application: V2.3.11
•
AFE application: V2.6.12
•
BCU application: V2.1.8 and V2.2.4
This monitoring value shows the measured heat sink temperature of the drive.
136 | Danfoss A/S © 2021.09
Monitoring value descriptions
AB319735759636en-000101 / DPD01822
Advertisement
Table of Contents
