Features Priority - NXP Semiconductors freescale KV4 Series Reference Manual

Functional description
• If POLn = 0, the channel (n) output polarity is high, so the logical one is the active
state and the logical zero is the inactive state.
• If POLn = 1, the channel (n) output polarity is low, so the logical zero is the active
state and the logical one is the inactive state.
39.5.18 Initialization
The initialization forces the CHnOI bit value to the channel (n) output when a one is
written to the INIT bit.
The initialization depends on COMP and DTEN bits. The following table shows the
values that channels (n) and (n+1) are forced by initialization when the COMP and
DTEN bits are zero.
Table 39-250. Initialization behavior when (COMP = 0 and DTEN = 0)
CH(n)OI
0
0
1
1
The following table shows the values that channels (n) and (n+1) are forced by
initialization when (COMP = 1) or (DTEN = 1).
Table 39-251. Initialization behavior when (COMP = 1 or DTEN = 1)
CH(n)OI
0
1
The initialization feature must be used only with disabled FTM
counter. See the description of the CLKS field in the Status and
Control register.

39.5.19 Features priority

The following figure shows the priority of the features used at the generation of channels
(n) and (n+1) outputs signals.
1000
CH(n+1)OI Channel (n) Output
0 is forced to zero
1 is forced to zero
0 is forced to one
1 is forced to one
CH(n+1)OI Channel (n) Output
X is forced to zero
X is forced to one
Note
KV4x Reference Manual, Rev. 2, 02/2015
Preliminary
Channel (n+1) Output
is forced to zero
is forced to one
is forced to zero
is forced to one
Channel (n+1) Output
is forced to one
is forced to zero
Freescale Semiconductor, Inc.